Door Station Wizard
The Door Station wizard will guide you through the basic configuration of a selected door station.
Also see:
Basic Requirements
- Make sure that the devices run the latest software otherwise the configuration could fail.
- Additional door stations (including S1x, S2x cameras) to be configured must be listed in the Device Bar.
- Apply the default password "meinsm" to all door stations. To do so, you can use the Secure System Wizard.
- Apply the default password "meinsm" to MxDisplay devices to be configured.
Step by step
- To open the Wizards & Tools view, right-click on the navigation key in the Command bar. Select the Wizards & Extras view.
Enlarge image
- Select the related door station (camera) Device bar or the Camera/Group bar and click Initialize Door Station. The Door Station Wizard starts up.
Enlarge image
- Read the introduction text and make sure you meet the basic requirements for the further configuration. Click Continue.
Enlarge image
- Select the devices you want to configure and click Continue. The Selected devices will be configured. This can take while.
Note: Only devices with suitable software can be selected. The Master door station cannot be deselected.
Enlarge image
- Check the summary of the configured devices and click Continue.
Enlarge image
- Follow the next remaining configuration steps and click Finish.
- Initialization of door station RFID module
- Add MxBell as remote Station
- Define all relationships between adresses and remote stations
- Configure I/O-wiring
- Final configuration of all door station (cameras)
- Setup MxDisplay
Enlarge image
Copyright © 2019 MOBOTIX AG. All rights reserved.
)
)
)
)
)
)